I was hoping you guys could point me in the right direction as to where I could get some revolver stocks properly fitted? They are NOS Colt Custom stocks made by Eagle. I played around a little with them with sanding, so that they fit onto the gun, but there's quite a bit of a gap on the right hand side as well as some under-hand in the back and overhang at the bottom.
Imgur: The most awesome images on the Internet
I didn't downsize the pictures, but I can easily get more if you guys would like more or different angles.
Kyarno, not sure where in CT you are located, however, I have had good results with my gunsmith located in Southport.
Mitch Schultz at 2 Lacey Place, Southport. His shop is called Gunsmithing LTD and is located behind the Strum, Ruger building.His phone number is 203-2540436. Ext. 21 off I-95 south. Good luck, Joe
I actually ended up calling Eagle and sent them out to Chicago this afternoon. I'm actually from Thompson, so basically the exact opposite end of the state haha