Search Results - Colt Forum

Search:

Type: Posts; User: Collects

Page 1 of 20 1 2 3 4

Search: Search took 0.28 seconds.

  1. Replies
    29
    Views
    803

    Skilled's stocks are imitation Ropers. The...

    Skilled's stocks are imitation Ropers. The checkering is too large (too deep, too wide, too few LPI) to be Ropers. There is no square mounting hole in the back side of the stocks. The back side...
  2. I like to use Eezox. Remove the stocks. Spray...

    I like to use Eezox. Remove the stocks. Spray it liberally into the small openings on both sides of where the trigger enters the frame, into the frame through the opening in the back of the gun,...
  3. Replies
    22
    Views
    1,067

    Best wishes to Paul for a speedy and full...

    Best wishes to Paul for a speedy and full recovery, with a minimum of pain and aggravation.
  4. Welcome back, Dave. I look forward to more of...

    Welcome back, Dave.

    I look forward to more of your long winded, interesting Colt related posts.
  5. Thread: New Collector

    by Collects
    Replies
    15
    Views
    243

    Welcome to the forum, from Ohio. My brother...

    Welcome to the forum, from Ohio.

    My brother lives in Oaxaca.
  6. Clean the revolver inside and out with Eezox. If...

    Clean the revolver inside and out with Eezox. If you do not like to take guns apart, then just hose down the insides of the gun with the Eezox from the outside, squirting fluid in the firing pin...
  7. I will take the Colt Cobra parts. PM to follow.

    I will take the Colt Cobra parts.
    PM to follow.
  8. I had no idea that the certificates of...

    I had no idea that the certificates of registration are so rare.

    Presumably, the mailing tubes are even more rare than the RM certificates. Likely, many of the mailing tubes were discarded upon...
  9. Check out ammoseek.com

    Check out ammoseek.com
  10. Replies
    22
    Views
    645

    Ozone generators work well to remove "off" smells.

    Ozone generators work well to remove "off" smells.
  11. Replies
    13
    Views
    571

    "Unfired" (meaning, not fired after the gun left...

    "Unfired" (meaning, not fired after the gun left the factory) is a much used and abused term.
  12. Coincidences abound! I had a similar terrible...

    Coincidences abound! I had a similar terrible boating accident.

    My boating accident resulted in the loss of ALL of my guns! I hope the Eezox and Renaissance Wax preserve the guns underwater until...
  13. I shoot pins with .38 special ammo. With a good...

    I shoot pins with .38 special ammo. With a good hit, the pin hits the dirt.

    Shooting pins is fun!

    I like to set up 30+ pins, then shoot them in random order, only deciding on the next pin to...
  14. Replies
    72
    Views
    3,538

    Congratulations on an excellent acquisition. I...

    Congratulations on an excellent acquisition. I would have happily paid $1,000 for that revolver.
  15. Replies
    42
    Views
    2,199

    If even 5%-10% (one half million to one million)...

    If even 5%-10% (one half million to one million) are found, the price of Mammoth ivory would decline significantly...and I would be a buyer.
  16. Replies
    22
    Views
    1,512

    "Unfired" is a much used and much abused term.

    "Unfired" is a much used and much abused term.
  17. Replies
    3
    Views
    172

    ebay has a couple pairs for sale

    ebay has a couple pairs for sale
  18. Replies
    42
    Views
    2,199

    It just struck me as extremely expensive, but not...

    It just struck me as extremely expensive, but not necessarily price gouging. After all, it is well over 10,000 years old (maybe 30,000 years old, perhaps older yet), is somewhat rare, and no new...
  19. Replies
    42
    Views
    2,199

    Last month, I was offered a piece of Mammoth...

    Last month, I was offered a piece of Mammoth ivory, big enough to make target stocks for a Python, for $1,000 for the ivory, plus $800 for expert carving. I passed.
  20. Replies
    18
    Views
    658

    Have you tried this? How did it work out?

    Have you tried this?

    How did it work out?
  21. Replies
    15
    Views
    570

    Consider placing pegboard on the wall, then...

    Consider placing pegboard on the wall, then hanging the guns from the pegs. You can buy some attractive pegboard.
  22. Replies
    18
    Views
    658

    I have inadvertently turned many of those old...

    I have inadvertently turned many of those old stocks from black to brown by washing the stocks in lukewarm water, with soap. I should have washed them in cold water, with soap.
  23. Sperm whale oil is no longer on the Brownell's...

    Sperm whale oil is no longer on the Brownell's website
  24. Replies
    34
    Views
    1,903

    Yet, it appears to be NIB.

    Yet, it appears to be NIB.
  25. Replies
    34
    Views
    1,903

    I have no interest in the beater CMP 1911s, with...

    I have no interest in the beater CMP 1911s, with way too many hoops to jump through in order to simply buy a pistol.

    Besides, I already own a Remington Rand 1911A1 in 99.9% condition (maybe 99.7%).
Results 1 to 25 of 500
Page 1 of 20 1 2 3 4
vBulletin Security provided by vBSecurity v2.2.2 (Pro) - vBulletin Mods & Addons Copyright © 2019 DragonByte Technologies Ltd.
We are not associated with Colt's Manufacturing LLC. We are an enthusiast site comprised of Colt Fans.
Powered by vBulletin® Version 4.2.3
Copyright © 2019 vBulletin Solutions, Inc. All rights reserved.
SEO by vBSEO ©2011, Crawlability, Inc.