Colt Forum banner

Discussions Showcase Albums Media Media Comments Tags Marketplace

1-5 of 5 Results
  1. The Lounge
    I got 53 more ready for the range today looking forward to the trip over there. Same amount of powder 23.5-24.3 grains of imr 4227 and the 240 grain jacketed flatnose bullets. Being shot from my ruger super blackhawk. The starline brass is more consistent as far as sizing and seating depth. I...
  2. Reloading & Range Reports
    Second batch of 50 44 mag reloads using 23-24.3 grains of imr 4227, and Barry's 240 grain plated flatnose bullets. The majority if them where charged with 23 5 grains. A had a good tight crimp. The first target in the photos with the middle not hollowed out is at 7 yards. The second photo was...
  3. The Lounge
    So I finally got around to reloading about 40 44 mag rounds. 22-23 grains of imr 4227 and Barry's plated 240 grain flat nose bullets. The cases need to be trimmed more uniformly I'm well aware of that. But the crimps held well no bullets jumped out of the case when I had more than one in the...
  4. Reloading & Range Reports
    I took a small selection of guns out today, and my friend showed up. And off of the AR500 steel plate, one of his 308 ricochets off the ar 500 plate bent the frame. The week before it was his 350 legend. I brought the marlin 336cs, the 1971 ruger super blackhawk, the Uberti gambler 45 lc...
  5. Colt Revolvers
    Posted this in another OP’s Anaconda thread without any response, so instead of hijacking his thread I wanted to start my own. I have noticed some Anacondas were rollmaked -Double Action Revolver- on the right side of the barrel and some (to a lesser degree) were marked - .44 MAGNUM CARTRIDGE-...
1-5 of 5 Results
Top