[Colt1911A1]

This is the Story,
I'm currentlly working on a 1933 Colt 1911A1 restoration project and had to mill the slide due to holster ware, pitting and worn markings.

 

[Colt1911A1]

Before I set the slide up in the mill I tryed a test run on this Casting First to make sure not to make any mistakes.
It went smoth.















I'm not a Gun Smith and don't think I'm going to complet this lower. I've had it as a paper weight on my desk for a year or so and its just going to be a test dummy for a bluing project after this point. After I get the bluing done, well I guess my Question is,...............................Dose anyone want a paper weight or Project?

 

[ColtM1911A1]

No pic's. Having problems?

 

[rhmc24]

I love projects, making guns from parts, reworking bubba victims, etc.

 

[Colt1911A1]

Thanks Again Rhmc24,
Sounds like you have been around. You think it would be hard to drill all necessary hole's with a gig?