Colt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
5 Posts
Discussion Starter · #1 · (Edited)
Looking at picking up a set of replacement springs while they are easily available (and cost is lower) for my 1971 vintage Colt 1851 Navy. I've found parts made by Uberti and Navy Arms. Anybody know what is the best set to pick up for fit & quality? Also, in the opinion category, is it recommended to pick up a complete set of replacement screws as well? Anything else I should be acquiring for use down the road. With the cost of shooting, my plan is to get lots of use out of this revolver. Many thanks in advance.

Thanks to all, I ordered a set of Uberti springs to have on hand. Same seller also has replacement screw sets, is there any need to have a set of screws. Unless I'm missing something, I can't think of one but I'm super new to this area of shooting so I have a lot to learn.
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top