Colt Forum banner
1 - 2 of 2 Posts

·
Registered
Joined
·
53 Posts
Discussion Starter · #1 ·
Can A 6\" Anaconda Be Cut Down To 2.5\"???

I would like to get a 2.5" Anaconda to go with my snubbie Python and Combat Cobra however, Colt never made snubbie Anacondas. Is there any gunsmith out there that can shorten a 6" barrel down to a 2.5"? I would think if you start out with a 6" barrel you have enough underlug area to mill out the recess for the ejector rod. Can longer barrels be milled down and rethreaded?

MadDog /forums/images/graemlins/confused.gif
 

·
Registered
Joined
·
53 Posts
Discussion Starter · #5 ·
Re: Can A 6\" Anaconda Be Cut Down To 2.5\"???

Thanks Rover,

The 2.75" Mini Anaconda is just what I am looking for. I am going to have it done, after I finish my Thompson "Tommygun" project, SBR my AR15, Turn my Winchester '92 into a Mares Leg, and suppress my FN Five-seveN.

Have just a few projects I am working on,
MadDog /forums/images/graemlins/tongue.gif
 
1 - 2 of 2 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top