Colt Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
4 Posts
Discussion Starter · #1 ·
Hi all, I'm new to the forum, and having a frustrating issue. I was cleaning my Mustang, and flipped the dreaded extractor down. I removed the grips and tried to partially push out the pin holding the extractor in, but succeeded in removing the sear as well. Now I have no clue how it goes back together in relation to the sear spring and the hammer. Searched the net, with no success, and fiddled with it for over 4 hours. Any tips, tricks, photos would be great. Especially of how the sear fits in correctly with the hammer. Or, should I bag up the parts and go to a gunsmith?Thanks!
 
1 - 3 of 3 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top