Colt Forum banner

1 - 4 of 4 Posts

·
Registered
Joined
·
242 Posts
Discussion Starter #1
Colt Python I Frame Small Panel Pearlike

I was thinking about these for a 4" Python.
Not crazy about factory grips feel, though I will keep them cause it would be dumb not to.
The size isn't a problem, just where the checkering lines up on my fingers.

Aren't these small grips usually for the short barrel pythons?
Opinions?
 

·
Registered
Joined
·
242 Posts
Discussion Starter #3
I can see going with rubber for the .44 magnum Anaconda but unnecessary for a four inch .357.I have smooth cocobolo on my six inch blue python and they work fine.Does anyone make smooth feaux pearl in the usual large size python grips? I think it would look good on my e nickel four inch and I'm not sure if I will like the look our feel of the smaller service sized grips.
 

·
Registered
Joined
·
3,998 Posts
just fyi.. i don't know if you'd be interested but i have a set of jay scott black pearlite python grips that i'd ship to you for 55 dollars.
 
1 - 4 of 4 Posts
Top