Colt Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
81 Posts
Discussion Starter · #1 ·
I just acquired a 1940 Colt Woodsman Match Target 1st Series pistol with a Stevens rear sight. I figured out how to adjust the elevation, but I am not sure about the windage. The sight has a large head screw on the right side and a slightly smaller head screw on top. The screw on the side moves about 1/2 turn left and right, but the screw on top will not move. Any suggestions???
Is there a way to remove this sight from the pistol? All suggestions will be appreciated.
 
1 - 3 of 3 Posts
Top