Colt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
11 Posts
Discussion Starter · #1 ·
this is an update on the a previous post
after re assembly the sideplate is installed and dry fire a ok w o problems
timing is correct
then here comes the cylinder and putting it in is tight then pulling the hammer in single action is tight
double action is tight and gets tighter and its bound ??
i will send it to colt today
curious on what i did wrong watched the videos and looked at my process and everything went well
up until the cylinder goes in
any input would be appreciated - learning process here
:(
 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top