Colt Forum banner
1 - 8 of 8 Posts

·
Registered
Joined
·
2,775 Posts
Discussion Starter · #1 ·
Another post hereabouts recently prompted me to show this. Pardon me if I've posted this previously, but then, you can't get too much of a fine Colt.



This is a Colt .357 Magnum SAA. The rear sight is from a Smith & Wesson, front sight is from Ruger, backstrap is 1851 Colt Navy, walnut grips my home made stuff.

Bob Wright
 

·
Registered
Joined
·
2,775 Posts
Discussion Starter · #8 ·
Bob,

Nice looking!
How did you remove the Colt front ramp sight before installing the Ruger ramp?
This wash a Single Action Army, so there was no ramp, only a blade. I didn't do the work, but assumed that since the Ruger sight was silver soldered, it was removed by torching.

Bob Wright
 
1 - 8 of 8 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top