Colt Forum banner

1 - 3 of 3 Posts

·
Registered
Joined
·
2,400 Posts
Discussion Starter #1
greeting i just purchased a new in the plastic box bomar bmcs rear sight for the 1911 , can someone give me a few pointer on how to install the sight properly, please advise rj
 

·
Registered
Joined
·
1 Posts
rj,
I suggest that a qualified machinist/gunsmith familiar with Bomar installation be consulted. The slide of the M1911 will need to be milled/ drilled to fit the sight. This of course assumes that you do not intend to mount the sight high like the GI match guns. If that is your intant then installation is easier. BTW these sights should meet your match requirements.
Chief

[This message has been edited by Chief (edited 09-30-2004).]
 

·
Registered
Joined
·
2,400 Posts
Discussion Starter #3
greetings chief yes intend to mount the sight high like the GI match guns. i have emailed bomar several time and no anwser to date and i am very disappointed in them , all i require is a few pointers as i have instaled millet sights before by hand but never a bomar , many thanks for all you help rj
 
1 - 3 of 3 Posts
Top