Colt Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
764 Posts
Discussion Starter · #1 ·
I have a few MkIII guns (Lawman, Trooper, OP), and just noticed what seems to be a set screw behinf the trigger; not in the frame, but in the trigger assembly itself. Anyone know what this is for?
 

·
*** ColtForum MVP ***
Joined
·
16,655 Posts
It is a trigger stop screw.

This screw really isn't intended for owner adjustment, being properly adjusted at the factory, and Loctited in place.

The danger is, attempting to adjust it for even less over-travel will cause internal action problems and a heavier trigger pull.

Best advice: Leave it alone, it was never intended for post-factory adjustment.
 

·
Registered
Joined
·
764 Posts
Discussion Starter · #4 ·
I have no intention of fooling with it. Just hadn't noticed them before, and wondered what they were. Thanks for the info.
 
1 - 4 of 4 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top