Colt Forum banner
1 - 3 of 3 Posts

·
Registered
Joined
·
1 Posts
Discussion Starter · #1 ·
Hi folks....so I have a Colt Mustang 380 Mark IV series 80 in my shop. Customer brought it in in pieces. I got new parts and have it together but I can't figure out why the hammer is not locking into the 'cocked' position? I have looked at diagrams and believe I have everything in place...is there some trick I'm missing? Ejector is in correct position..... hell my 1911's haven't even stumped me like this before! Any help would be appreciated!

Thanks in advance!
 

·
Premium Member
Joined
·
1,453 Posts
Go to UTube and find a video for the Mustang disassembly/assembly. Whenever I get stumped, this always helps.
 

·
Registered
Joined
·
769 Posts
Check the sear. I had one come in that the seller had installed upside down, then filed on it to try to fix it.
 
1 - 3 of 3 Posts
Top