Colt Forum banner
1 - 1 of 14 Posts

· Registered
487 Posts
For the 2020 Python, since it's stainless and a shooter, I put Pachmayr rubber grips that wrap around the backstraps on it. These are the no finger groove model with the silver colt medallion.

The factory grips suck. They are laminate, and they are too narrow and slippery. The Pachmayrs are 10x better for shooting.

Make no mistake, if this was a V-spring Python, I would not be putting rubber grips on it, but for the 2020 they are appropriate, look okay, and perform much better than the garbage it comes with. Plus they hide the bare, not serrated I'm not reminded of the cost cutting. :D
1 - 1 of 14 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.