Colt Forum banner
1 - 4 of 4 Posts

·
Registered
Joined
·
27 Posts
Discussion Starter · #1 ·
There is a guy on the Bullseye list that needs a barrel for a .38 Officers Model Match. Since they haven't been made for about 37 years is there anywhere to look for a barrel? It was also suggested that the barrel could be relined. Any ideas about that would be great.

Thanks,


Dwight
 

·
Registered
Joined
·
778 Posts
I would probably look for a beat up one at a gun show. That way he can check the bore. Then just use it for parts.

In any case in the end he may be better off to buy a good new to him used one, as in the end that may be cheaper than paying to have barrels switched, etc.

The OM's are some of our favorite revolvers. They just don't make em like that anymore.
 
1 - 4 of 4 Posts
Top