Colt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
205 Posts
Discussion Starter · #1 ·
Here's a matching set I sent out not too long ago. The big dude is for a Kimber 1911 in 10mm with a compensator attached bringing it to the overall length of a 6 inch 1911. I should have taken a picture while I was wet molding it. I had the dummy in the holster, and also had my 1911's muzzle sticking in the open toe to create the extra slide length to properly mold it. The other holster is for a Sig 220. The customer wanted them as low as possible with a mild forward rake of 7 degrees. Made for a 1.75 inch belt.

Paul








 
1 - 1 of 1 Posts
This is an older thread, you may not receive a response, and could be reviving an old thread. Please consider creating a new thread.
Top