Colt Forum banner
1 - 1 of 1 Posts

·
Registered
Joined
·
7 Posts
Discussion Starter · #1 ·
I'm thinking about looking for a 2-1/2 inch Diamondback 38 for a carry gun. I would probably buy one that is either unfired or has rarely been fired. I have read that there are wearable parts like the hand that were meant to wear and be replaced at certain intervals and that failure to do so results in damage to other parts. None of these parts are available from Colt to the best of my knowledge. In addition, from what I've read, it is very difficult to find qualified gunsmiths that can work on these guns.

So my question is---if one bought one of these guns and then needed repair work performed are there any places left that can provide wear parts and do the necessary fitting?
 
1 - 1 of 1 Posts
Top