Colt Forum banner
1 - 20 of 29 Posts

·
Premium Member
Joined
·
6,299 Posts
A sweet Colt SAA with a fine letter. Thanks for sharing it with us. 👍👍
 
  • Like
Reactions: Cwsmith25 and jrm

·
Registered
anything Colt 1st gen and lever action Marlins
Joined
·
540 Posts

·
Premium Member
Joined
·
5,818 Posts

·
Premium Member
Joined
·
5,818 Posts
What's wrong with it.
Carefully remove the grips. Remove BS and TG. Make sure that gate screw is flush with the frame bottom. Then replace the BS and TG, and tighten all screws.

Tightening the TG screws often results in a bent TG. It bends over that protruding head of the gate screw.

The grips should fall into place, without any forcing whatsoever. Forcing results in chipping. If not falling into place, loosen BS and TG screws, and locate grips in place,and then tighten all screws.
 
1 - 20 of 29 Posts
Top