Colt Forum banner

1 - 20 of 107 Posts

·
Premium Member
Joined
·
1,935 Posts
Discussion Starter #1
No pictures I can share, but I did just see pictures of them on a Colt employe’s phone. They are assembling them now and they should be in circulation late August or early September....also saw some with different color Cerecoke finishes, really nice looking. They will be here soon. Steve
 

·
Premium Member
Joined
·
1,935 Posts
Discussion Starter #7
I don’t know anything about a “new” Python but I did suggest they make this DA in .22 in 2” and 3”, fixed and adj site in each length.....and a run of 22 magnums as well.
 

·
Premium Member
Joined
·
593 Posts

·
Premium Member
Joined
·
87 Posts
MSRP of $999? Then, I’m guessing a new “Python” would be pushing an MSRP of $1,499 or more. Getting a little pricey IMO.
 

·
Registered
Joined
·
399 Posts
I believe the minimum length is 105 mm. I think most companies that opt to meet that target go a little above it.
 

·
Registered
Joined
·
633 Posts
Beating that dead horse (new Python) is not productive.

I knew it & so did you that Colt would put adjusable sights on the new KC!

Memo to Colt: extend the barrel to 4.2" or 107mm, add adustable sights and watch sales take off!!!
(where the F is Kimber?)
 

·
Registered
Joined
·
276 Posts
I see it’ll be a Canada-legal barrel like the current S&W 19. Good for them.
Good for them no doubt. It will be legal there before it's legal in CA. :(

I would have preferred a 5" or 6" barrel. For some reason a 4" barrel to my mind still should have fixed sights.
 

·
Registered
Joined
·
9,951 Posts
Nice looking but I can't say I like the Colt medallion mounted so high on the stocks...just doesn't look right.
 
  • Like
Reactions: ei8ht and marrunred

·
Registered
Joined
·
168 Posts
I agree the medallion is a bit high but I think it looks great. It's exactly what I've been waiting on and I will be a buyer! Hope there's some good leather available for it.
 
1 - 20 of 107 Posts
Top